bus configuration
英 [bʌs kənˌfɪɡəˈreɪʃn]
美 [bʌs kənˌfɪɡjəˈreɪʃn]
网络 总线型结构; 总线结构; 汇流排架构
双语例句
- Use "Placeholder" for the business name, and "This holds services for WS Bus" for the business description ( assuming the default Bus configuration).
将业务名命名为“Placeholder”，并用“ThisholdsservicesforWSBus”作为业务描述（假设缺省总线配置）。 - You may want to restore the Bus configuration to the state it had before you ran the example in this article& that is, to undeploy the bus services.
您也许想要把您总线的配置恢复到运行本文中示例之前的状态-即恢复为没部署总线服务。 - You can also make the calls asynchronous and check the underlying Service Integration Bus configuration on the administrative console.
您也可以在管理控制台中使调用异步化以及检查基础ServiceIntegrationBus配置。 - Bat; this undeploys the three stock quote services and the UDDI registry from the Bus off-ramp configuration.
这从总线出站配置中就清除了部署的三种股票报价服务和UDDI注册中心。 - Finally, if cross bus communication is being used, you need to specify InboundSecureMessaging as the inter-engine transport chain on the bus configuration panel.
最后，如果使用交叉总线通信，则需要在总线配置面板中指定InboundSecureMessaging作为引擎间传输链。 - BPC SI Bus Data Source Configuration
SIBus数据源配置 - We can add our server to the bus with the bus configuration screen by selecting bus members
通过选择总线成员，可以将我们的应用服务器添加到带有总线配置屏幕的总线中 - Solutions for Four-section Single Bus Configuration Problem in Installment Construction of Substation
变电站分期建设中单母线四分段接线问题解决馈电线调度投切和自动分段 - PCI Bus Configuration and Implementation Technique
PCI总线配置及实现技术 - Computer supervising system using CAN bus and configuration software technology
利用CAN总线和组态软件构建计算机监控系统 - Firstly, the structure of software bus and configuration is introduced.
首先，介绍了软件总线和软构件的结构。 - Development of CAN bus control system configuration software based on COM component
基于COM组件的CAN总线控制系统组态软件开发 - This paper also analyzes the internal structure of the interface, and gives the design of PCI bus configuration and the realization of target state machine in the interface of PCI.
本文还分析了接口内部实现结构，给出了PCI总线配置空间的设计以及目标状态机的实现。 - The paper introduces the property of PCI bus, describes the signals, commands and the transfer protocol of PCI bus, configuration technologies and DMA transmission technologies.
论文介绍了PCI总线的特点、PCI总线规范、PCI总线配置技术和PCI总线的DMA传输技术。 - Application in High-Frequency Quenching System of CAN Bus and Configuration Software
CAN总线控制系统的组态软件应用初探 - Compared with conventional fault location based on fundamental components, traveling-wave based fault location is more accurate and not apt to be affected by transition resistor, fault type, distributed capacitance, bus configuration and CT saturation, etc.
与传统的基于工频量的故障测距技术相比而言，基于行波的测距技术不易受系统运行方式、过渡电阻、CT饱和、线路分布电容的影响，测距精度高。 - Substation Supervisory System Based on CAN bus and Configuration Technology
基于CAN总线和组态技术的变电站监控系统 - 1394 OHCI program realized the test of 1394 bus configuration, the status transfer of physical layer, the transmission and reception of 1394 asynchronous packets.
1394OHCI程序设计包括总线配置检测、物理层状态传送、异步数据包的发送和接收的实现。 - The paper presents a method to evaluate the reliability of bus configuration by the time sequential simulation.
提出了用时序模拟法对电气主接线进行可靠性评估。 - The Research and Application of Bus Configuration of 306 kA Pre-bake Anode Reduction Pot
306kA预焙阳极电解槽母线配置的研究与应用 - Based on the seismic reliability analysis of double-bus configuration system, the seismic reliability analysis of double-bus with auxiliary bus configuration is discussed in this paper.
在双母线系统抗震可靠性分析的基础上，进一步讨论了高压变电站另一种重要接线形式&双母线带旁路母线接线系统的抗震可靠性分析问题。 - Reliability Evaluation of Bus Configuration Based on Time Sequential Simulation Technique and Petri-Net
基于时序模拟法和Petri网的电气主接线可靠性评估 - Secondly, the dynamic process of bus configuration varying with the changes of breakers are analysis by the coloured Petri-net model and the topology analysis algorithm based on the coloured Petri-net.
其次利用有色Petri网模型以及基于该Petri网的电网拓扑分析算法，对主接线由于开关变化引起网络变化的动态过程进行分析。 - Field control bus and configuration software are effective methods that compose of each subsystem's hardware and software.
现场控制总线和组态软件是构成各种子系统硬件和软件的有效实现方法。 - Subsequently, PCI Bus technology is generally introduced, including the major features of PCI Bus, the concepts of basic signal, PCI Bus operation and configuration space of PCI device.
接着，对PCI总线技术进行了概述，包括PCI总线的特点、基本的PCI总线信号组、PCI总线的操作和配置空间。 - By using PS ( passive serial) configuration scheme, the configuration data are loaded into FPGA that is on an ISA card through ISA bus. The configuration principle and related hardware and software design are described in detail.
采用被动串行PS配置方式，在PC机上将配置数据通过ISA总线写入ISA插卡上的FPGA中，详细介绍了配置原理及有关的硬软件设计。 - The development of automated production line also has become one of necessary trends of technology development in the current automation field with fast development of domestic manufacturing and wide application of programmable controller technology, field bus technology and configuration technology.
随着国内制造业快速的发展，可编程序控制器技术，现场总线技术和组态技术的广泛应用，研制自动生产线也就成为了当今自动化领域技术发展的必然趋势之一。 - At first, PCI bus protocol and electrical specification are analyzed in this paper, data transfer and the function of PCI bus configuration space and its structure are also discussed.
本文首先分析PCI总线的电气规范和PCI总线协议，讨论PCI总线的数据传输及PCI总线配置空间的组织和功能，提出了PCI总线开发的具体方案。 - The bus configuration of Wishbone is simple, flexible, and has much free resources.
Wishbone总线配置简单、灵活，有丰富的免费资源。